This kit includes a plug and play harness that will allow you to use your 8" factory radio display and toggle between your factory installed tailgate camera and this third brake light camera when in reverse. This is a trim bezel with premounted camera that fits behind your factory 3rd brake light and adds the rear camera convenience to the top of your cab! Now you can see your fifth wheel or anything else that is inside your bed without having to have a spotter guiding you for trailer connections etc. Adds a trim bezel with premounted camera to your factory third light assembly and the camera connects to the same connector that your factory rear camera uses. The included plug and play harness allows you to choose which camera you want to display when in reverse. A switch determines which camera will be displayed when in reverse.
Notes about the included integration cable:
- Truck must have a rear view camera that was installed at the factory and is displayed on your factory radio screen (2015-18 models only)
- Kit includes a plug and play harness that allows you to connect both your factory tailgate camera and this 3rd light camera to your factory radio. The switch allows you to choose which one is displayed in reverse.
- 3rd brake light trim bezel with premounted camera
- HD CMOS, high resolution color and night vision
- Adjustable view, swivel head allows you to aim the camera where needed
- 500 TV Lines of resolution
- 150 degree view
- <.2 LUX night vision
- 3 Year warranty
2013-2016 Ford Super Duty trucks with 8" factory display and factory tailgate camera.
Remove your factory 3rd brake light and install the trim bezel from this kit, then reinstall your factory light. Remove the radio to gain access to the camera connector, install new plug and play harness, route camera harness to the T-harness and make connections. Power connections for camera must also be made inside the cab.
Make installation even easier with an add on 12 Volt power source to eliminate the need to locate a power source on the vehicle and avoid cutting or splicing into factory wiring! See related item SKU: CS-RPW-P
Vehicle Interface: Not Included
Waterproof/Dustproof Level: IP 67
Night Vision: < .2 Lux
Power Supply: 12 Volts
Wiring Type: Hard Wired Full Harness
System Manufacturer: EVI Systems
Camera Resolution: 500 TVL
Camera Orientation: Rear Facing
Fit Type: Factory OE Fit Replacement
Connection: RCA with opt. Factory Interface
Sensor Type: CMOS
Sensor Brand: EVI System
Viewing Angle: 150 Degrees
Warranty: 3 Year Limited
HEAR FROM OUR SHOP
“The 5th wheel cams are easy to install once you take out everything that’s ‘in the way’. You have to take out the passenger kick cowl, passenger front and rear thresholds, the lower part of the B and C pillars and drop the headliner. Next, you fish the wire up the C pillar and run it all the way back to the dash. Then, you unplug the stop lamp, run the wire for the camera through behind the headliner down to the lower C pillar, lay the camera over the stop lamp and screw them in place on the cab, make the connection in the C pillar, and put everything you removed back together.” — Steven Ernster // JUNE 2020